ここから本文です
TWO:"I dare say," he answered carelessly. "Come and meet him. You'll like him."
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:Landor consulted with his lieutenant. "Very well," he said in the end, "I'll go. I take serious risks, but I understand it to be the wish of the citizens hereabouts."[Pg 114] Their envoy assured him that it most certainly was, and became profuse in acknowledgments; so that Landor shut him off. He had come many miles that day and must be on the march again at dawn, and wanted what sleep he could get. "When and where will you meet me?" he demanded with the curtness of the military, so offensive to the undisciplined.

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:The Lawton woman had heard of an officer's family at Grant, which was in need of a cook, and had gone there.It was the always expected, the never ceasing. Landor looked at his wife and stroked his mustache with[Pg 75] a shaking hand. His face was yellow, and his hair had grown noticeably grayer.
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:She was quite alone, wandering among the trees and bushes in the creek bottom, and her hands were full of wild flowers. She had pinned several long sprays of the little ground blossoms, called "baby-blue eyes," at her throat, and they lay along her white gown prettily.[Pg 274] She stopped and spoke to him, with a note of lifelessness in her high, sweet voice; and while he answered her question as to what he had been doing since she had seen him last, she unpinned the "baby-blue eyes" and held them out to him. "Would you like these?" she asked simply. He took them, and she said "Good-by" and went on.

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.